. I am not sure how to get into the area you are describing. I was also wanting to know where in the software can I tell what kind of thermistor input this controller is looking for. So I am assuming it is correct, but I also didn't go through the steps that you listed above to upload the programming from the controller to be sure. Not something you learn on the fly.
Visual Logic is just fluff anyways for these new fangled younguns to program with blocks and the people who have little business in programming to use anyhow. Then hit F8, F8, F2, F4. Maybe if your problem isn't a major one, have some patience and wait until the end of May or June and then upgrade your system? I saw something about those commands in the programming manual. Well to get the input setup correctly happens by clicking the controller located in the lower right hand corner of the first Visio page. I know in the Visio file it showed 10K Degrees F. I can't say that I have ever had an Alerton controller quick reading an input like you are describing.
Alerton ms 1010 bt manual are available through our partner websites, information can be found after you fill enrollment form. I do not know what type of Front end you have on here but be careful. If it a standard piece of equipment there are prebuilt programs in the Alerton software. In Alerton's Bacnet product, Visualogic using Visio programming may be done if desired, but there is a text program editor that is always available. That was the old fashioned way of doing it.
If they didn't, depending on the size of your site, you may be better off just swapping the controller. It reads -98 without anything connected. Your browser may also contain add-ons that send automated requests to our search engine. If this is the case, we recommend disabling these add-ons. If you have any problems with the registration process or your account login, please. I actually did stop by radio shack and do just that. You'll need to purchase it from your local Rep since Alerton is fairly strict on their dealers territories, or at least they were in the past.
As for your problem, I would stop by Radio Shack and pick up a package of 10,000 ohm resistors. I would run a cross reference in the global controller ddc first and see if they did it that way. Then hit F8, F8, F2, F4. If they didn't, depending on the size of your site, you may be better off just swapping the controller. Alerton vlc-853 manual Why did this happen. Wire one of those into your input and you should 77 degrees. You might be better off to get a new controller and just replace the entire unit.
I'm sure they would be more than happy to send another technician out to actually solve the problem rather than tarnish their reputation without charge as long as it's related to the original issue at hand. Any information you can give me on these controllers will help out a bunch. Easy to cancel your membership. Leave the guy alone your probably annoying him Do you have an Alerton front end? Sounds like you may not be giving him enough time , or fully understand what he was doing. Will this do something bad to the files or was someone just trying to read the code? I am not sure if that did anything to it or not? If they didn't, depending on the size of your site, you may be better off just swapping the controller. This paper is an academic.
In Alerton's Bacnet product, Visualogic using Visio programming may be done if desired, but there is a text program editor that is always available. Library book collections, peer-reviewed journals, and online databases provide quality access to scholarly information. I would run a cross reference in the global controller ddc first and see if they did it that way. Then hit F1, and your done. Or is it something else? So I set it up for 10K ohm Temperature, and assured the jumper on the controller itself was configured.